ISO/TS 19857:2021

مواصفة قياسية دولية   الإصدار الحالي · اعتمدت بتاريخ ٢٥ يونيو ٢٠٢١

Paper, board and printing inks – Printability – Laboratory test method for offset ink setting

ملفات الوثيقة ISO/TS 19857:2021

الإنجليزية 22 صفحات
الإصدار الحالي
165.6 USD

مجال الوثيقة ISO/TS 19857:2021

This document describes a laboratory test method, using an IGT1-type or a prüfbau2-type printability tester, for the preparation of specimens to evaluate the absorption rate of an ink on a substrate in offset lithography by setting-off the printed surface to an unprinted surface.

This method describes testing with an amount of ink simulating either single colour or multi-colour printing. The print and the set-off print (counter print) are made with interval times, between print and set-off, common for the target process.

This method evaluates a particular ink and substrate combination.

 

1These materials are available from IGT Testing Systems, www.igt.nl. This information is given for the convenience of the users of this document and does not constitute an endorsement by ISO of the products. Equivalent products may be used if they can be shown to lead to the same results.

2These materials are available from prüfbau, Dr.-Ing. H. Dürner GmbH, www.pruefbau.de. This information is given for the convenience of the users of this document and does not constitute an endorsement by ISO of the products. Equivalent products may be used if they can be shown to lead to the same results.

الأكثر مبيعاً

GSO 150-2:2013
 
مواصفة قياسية خليجية
فترات صلاحية المنتجات الغذائية - الجزء الثاني : فترات الصلاحية الاختيارية
YSMO GSO 150-2:2020
GSO 150-2:2013 
لائحة فنية يمنية
فترات صلاحية المنتجات الغذائية - الجزء الثاني : فترات الصلاحية الاختيارية
YSMO GSO 2055-1:2020
GSO 2055-1:2015 
مواصفة قياسية يمنية
الأغذية الحلال – الجزء الأول : الاشتراطات العامة للأغذية الحلال
GSO 2055-1:2015
 
لائحة فنية خليجية
الأغذية الحلال – الجزء الأول : الاشتراطات العامة للأغذية الحلال

اعتمدت مؤخراً

ISO 24690:2025
 
مواصفة قياسية دولية
Glass reinforced thermosetting plastic (GRP) pipes — Test method for the determination of long-term pressure endurance strength
ISO 15614-11:2025
 
مواصفة قياسية دولية
Specification and qualification of welding procedures for metallic materials — Welding procedure test — Part 11: Electron and laser beam welding
IEC/TS 81001-2-2:2025
 
مواصفة قياسية دولية
Health software and health IT systems safety, effectiveness and security — Part 2-2: Guidance for the implementation, disclosure and communication of security needs, risks and controls
ISO 37190:2025
 
مواصفة قياسية دولية
Guidance for practical implementation of ISO 37155 series for supervising at each life cycle phase of smart community infrastructures